Flat End Threaded Sockets
Threaded socket forms with a flattened end and transverse hole. Define the hole position, flat-section dimensions and internal thread for your project.
View product →
Swipe to explore the product views.
Square Head T Bolts
Externally threaded fasteners with a square flat head. Define the head footprint, thread and shank dimensions to suit the specified mating assembly.
- Flat square head below an externally threaded shank.
- Male thread interface rather than an embedded female-thread socket.
- Head fit, shank proportions and mating hardware requirements defined by drawing.
Share your drawing, material specification and quantity.
Defined by the details.
Square head T bolts are externally threaded fastener components with a flat square head. Unlike the internally threaded inserts in the same hardware category, the illustrated part presents a male threaded shank for engagement with a separately specified mating component.
Head footprint and shank dimensions
The square head length, width and thickness need to be defined together with shank diameter, total length and threaded length. The head-to-shank transition and the unthreaded section below the head should also be shown if they affect the intended assembly.
If the head is intended to engage a slot, recess or channel, supply the mating geometry and any required orientation or clearance. The square outline alone does not establish compatibility with a channel system or a particular slot width. The final fit depends on the agreed drawing.
An external-thread component with its own specification
Use the complete thread designation, pitch and tolerance class to identify the male interface. Any nut, washer, insert or other mating component must be defined separately, along with the scope of supply.
Photographs do not establish a fastener strength class, a one-piece construction method or a rated tightening torque. State the required material, mechanical documentation and head construction in the inquiry. Critical head and shank dimensions and applicable thread checks can then be agreed as part of acceptance planning.
Information for a quotation
Tolerances, order quantity and lead time are assessed for the project.
Send your drawing →- Square head length, width, thickness and required corner geometry.
- Shank diameter, threaded length, unthreaded length and total length.
- External thread designation, tolerance class and mating-part drawing.
- Material, head construction requirements, mechanical documentation, quantity and inspection scope.
Buyer questions
Will this fit any T-slot or cast-in channel?
No universal fit is stated. Provide the channel or slot drawing, including head clearances and engagement requirements, for a component comparison.
Is a nut or washer supplied with the bolt?
Specify the required assembly in the inquiry. The product image shows the bolt form and does not define a nut or washer package.
Can the strength class be identified from the picture?
No. Required mechanical properties and supporting documents must be stated and confirmed separately; a photograph cannot establish a strength class.
Have a part in mind?
Share your drawing and requirements. Let’s discuss the manufacturing route.
Related Products
Compare other component forms for your drawing requirements.
Hex Foot Ferrules
Internally threaded ferrules with a hexagonal foot. Define the body length, thread engagement and base geometry for your concrete connection project.
View product →
Flat Plate Lifting Anchors
Threaded socket components with a square flat base plate. Specify the plate dimensions, socket height and connection details for project review.
View product →